04-08-2021, 22:21
Hi
I just compiled and setup my AQM with SPS30, SCD30 and BME280.
SPS and BME are showing values, SCD is showing no Temp/HUM or CO2 values.
If I connect only BME280 and SCD30, at least Temp and Hum from SCD is shown, but no CO2.
Now I recompiled to MH-Z19B with BME280 and SPS30 and all is working fine.
Is it possible that both Sensirion are not working together or is the SCD30 broken?
Any ideas?
Many thanks
Jochen
I just compiled and setup my AQM with SPS30, SCD30 and BME280.
SPS and BME are showing values, SCD is showing no Temp/HUM or CO2 values.
If I connect only BME280 and SCD30, at least Temp and Hum from SCD is shown, but no CO2.
Now I recompiled to MH-Z19B with BME280 and SPS30 and all is working fine.
Is it possible that both Sensirion are not working together or is the SCD30 broken?
Any ideas?
Many thanks
Jochen