AQM III Box - Printing 3D

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Linear Mode

tobyportugal
WeatherDuino 4Pro User

Posts: 54
Threads: 13
Joined: Dec 2019

Country: Portugal

#10

16-06-2021, 16:09

Hello,

A small logo test for the "rain cover" box.
If the logos are available in a better resolution than the one I copied (the one on the top left of the forum), I'm interested.
The result is not very nice. Undecided

BME solution to put them as close as possible to the air intake of the sensors (PMS/SPS). It can be glued right at the entrance of the air hole.

https://filedn.com/lxtJY18lcdpH0L6MOjBnG...-06-23.jpg
https://filedn.com/lxtJY18lcdpH0L6MOjBnG...-07-14.jpg

Find

« Next Oldest | Next Newest »

Messages In This Thread

AQM III Box - Printing 3D - by tobyportugal - 09-06-2021, 20:16

RE: AQM III Box - Printing 3D - by werk_ag - 09-06-2021, 22:17

RE: AQM III Box - Printing 3D - by tobyportugal - 10-06-2021, 05:54

RE: AQM III Box - Printing 3D - by laulau - 10-06-2021, 12:32

RE: AQM III Box - Printing 3D - by tobyportugal - 10-06-2021, 13:54

RE: AQM III Box - Printing 3D - by tobyportugal - 13-06-2021, 10:00

RE: AQM III Box - Printing 3D - by werk_ag - 13-06-2021, 16:31

RE: AQM III Box - Printing 3D - by tobyportugal - 13-06-2021, 19:34

RE: AQM III Box - Printing 3D - by werk_ag - 13-06-2021, 20:11

RE: AQM III Box - Printing 3D - by tobyportugal - 16-06-2021, 16:09

RE: AQM III Box - Printing 3D - by tobyportugal - 17-06-2021, 05:29

View a Printable Version

Users browsing this thread: 1 Guest(s)

Login
Username:
Password:	Lost Password?
	Remember me