1. WeatherDuino Forum
  2. Weather Stations & Environmental Measurement Equipment - WeatherDuino 4Pro Line
  3. General Talking
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

Linear Mode
AQM III Box - Printing 3D
tobyportugal
WeatherDuino 4Pro User
*****
Posts: 54
Threads: 13
Joined: Dec 2019

Country: Portugal
#3

10-06-2021, 05:54
(09-06-2021, 22:17)Werk_AG Wrote:  For outdoor use I would suggest PETG, as it is resistant to UV.

Hello,

This box will not be in direct contact with the sun.
I'm going to start/customize this kind of shield to protect from the sun and rain. It will house my four sensors.

[Image: 2021-06-10_06-42-29.png]
Find
Reply
« Next Oldest | Next Newest »


Messages In This Thread
AQM III Box - Printing 3D - by tobyportugal - 09-06-2021, 20:16
RE: AQM III Box - Printing 3D - by werk_ag - 09-06-2021, 22:17
RE: AQM III Box - Printing 3D - by tobyportugal - 10-06-2021, 05:54
RE: AQM III Box - Printing 3D - by laulau - 10-06-2021, 12:32
RE: AQM III Box - Printing 3D - by tobyportugal - 10-06-2021, 13:54
RE: AQM III Box - Printing 3D - by tobyportugal - 13-06-2021, 10:00
RE: AQM III Box - Printing 3D - by werk_ag - 13-06-2021, 16:31
RE: AQM III Box - Printing 3D - by tobyportugal - 13-06-2021, 19:34
RE: AQM III Box - Printing 3D - by werk_ag - 13-06-2021, 20:11
RE: AQM III Box - Printing 3D - by tobyportugal - 16-06-2021, 16:09
RE: AQM III Box - Printing 3D - by tobyportugal - 17-06-2021, 05:29



Users browsing this thread: 2 Guest(s)
  1. WeatherDuino Forum
  2. Weather Stations & Environmental Measurement Equipment - WeatherDuino 4Pro Line
  3. General Talking