01-04-2015, 05:33
(01-04-2015, 01:29)Werk_AG Wrote: If I correctly understood, you are trying to test the temp / hum sensors on a breadboard, not in the TX board.
Are you sure you have connected the sensors to the right pins on the Arduino?
Have you installed the pullup R7 resistor?
Can you please copy and past here your user config options. The long string that you are getting can also be useful, past it too, please.
I have checked my connections on the breadboard and can confirm the following
1. 10k pullup resistor is connected to VCC and Data of the DHT22 sensor
2. Data (pin2) output is connected to D9 input of the Arduino
3. Confirmed power of 4.7v being supplied via computer/usb connection and this is applied to sensor +ve pin1 -ve pin4 from the 5v output and gnd pins on the Arduino board
Requested files are attached. I assumed config options you were after were the modifications made to the TX file prior to compile and load, ie Local_Test etc..
