Hello tyntop,
You're not being naive, there is no dedicated power connector on the board. The board requires +5V. I use an old Ipod charger.
Take a look at the schematic diagram here:
http://www.meteocercal.info/forum/Thread...Schematics
You can connect +5v to any spare header that connects to Vin of the voltage regulator IC1. GND can go to any GND connection. If you are planning on using a TFT display, the LCD header will be free and so this is a handy place to apply power. This is what I've done and it works fine.
Kind regards,
Zack_ster
You're not being naive, there is no dedicated power connector on the board. The board requires +5V. I use an old Ipod charger.
Take a look at the schematic diagram here:
http://www.meteocercal.info/forum/Thread...Schematics
You can connect +5v to any spare header that connects to Vin of the voltage regulator IC1. GND can go to any GND connection. If you are planning on using a TFT display, the LCD header will be free and so this is a handy place to apply power. This is what I've done and it works fine.
Kind regards,
Zack_ster
(23-03-2015, 15:58)tyntop Wrote: Hi,
I have been looking at the wireless display part of the project and please excuse my nievety but I can not see how or where the power supply is connected to the board. Also what power supply voltage required ?
regards
tyntop.