13-02-2021, 04:35
3D Printed Radiation Shield for Meteo Stations - Part 6
STL files for 3D print the Radiation Shield
Everything prints fine with 0.3mm resolution, without supports.
30 to 40% infill for the wall mounting piece.
Ideally, for UV protection and additional mechanical resistance, it should be printed using ASA, PETG or ABS.
I printed mine in PLA and painted all pieces (except the sensor mounting and protection chamber pieces) first with a primary for plastic, then three coats of enamel acrylic ink. Let's see how long it lasts.
This thread is now open for discussion, feel free to comment on.
To finish, I would like to apologize each of you, by had the tolerance of reading this article written in a poor English.
Thank you.
STL files for 3D print the Radiation Shield
Everything prints fine with 0.3mm resolution, without supports.
30 to 40% infill for the wall mounting piece.
Ideally, for UV protection and additional mechanical resistance, it should be printed using ASA, PETG or ABS.
I printed mine in PLA and painted all pieces (except the sensor mounting and protection chamber pieces) first with a primary for plastic, then three coats of enamel acrylic ink. Let's see how long it lasts.
This thread is now open for discussion, feel free to comment on.
To finish, I would like to apologize each of you, by had the tolerance of reading this article written in a poor English.
Thank you.