[xxDvDxx]

Hi,

I would like to help, but i need more specific info.

Try enabling the

Code:

//#define PRINT_DEBUG_WU_UPLOAD

removing the two "//" on that line.

you may have to remove the "//" on those two lines too

lines 122 and 123 at NET tab

Code:

//time_t UTC_time = myTZ.toUTC(now());
//sprintf(dateutc, "%d-%02d-%02d+%02d%%3A%02d%%3A%02d", year(UTC_time), month(UTC_time), day(UTC_time), hour(UTC_time), minute(UTC_time), second(UTC_time));

Compile and upload.
Then, what you get on the serial monitor? It should output something when it tries to send data to WU.

If it isn't receiving data from the rain gauge, how the system initialize after a reboot or after programming it? At startup if it don't get data from the Rain Gauge, it will stay forever on the "gathering data from sensors" screen, unless you are running it in TEST mode. However, if it is running in TEST mode, then the WU upload function will not run (this is to prevent sending wrong or incomplete data to WU).

Just to be sure, this is the WU key you need to use:

Hi, about the WU key , yes I still using that part you shown in the print screen and I never changed that part anyway. About the startup on receiving rain gauge data , it still in “gathering data from sensors “ status till its timeout and go in the main view ,but obviously doesn’t show the rain data .
Will try enabling the debug part first , cause I saw u posted a “time” part that makes me think about a library update I did in the IDE updating process.
I will let you know results . Thank you in advance.