[xxDvDxx]

You have exposed the weak point of the Auriol weather station. The whole WeatherDuino project started because my first weather station was an Auriol, and very soon I noticed that the moisture and temperature data are very unreliable. My first aproach was build a build a transmiter just to use a reliabe T/H sensor, and keep all the other data from the Auriol. Later project evolved to what is is now.

My best sugestion for Auriol owners, still is build a TX unit, with just a T/H sensor inside a good radiation shiled, and configure the software to get T/H data from the built transmitter, while keep receiving Wind and rain data from the original Auriol.

Just tested and it’s a real “Moisture sensor” I just tried again with a drop of water on it and I reported after few minutes that the percentage of “ humidity “ changed from 22 to 80% , but only in the Auriol display, not in the ProCompact2 unit .

Data on the Pro2 Compact not necessarily update at the same time than in the Auriol display, especially when there is a huge change (more than 25%) from previous value (Weatherduino software uses spike control routines for moisture from Auriol)

Rgs

Hello, about your suggested to build a TX , what module you suggest to use ? I see in the tx board part listing there is a KXD-10036 RF Transmitter Module, is it that one in the pic attached?