[xxDvDxx]

Hi all, I just unmounted the wind and temperature sensor unit ( AURIOL H13726A ) for cleaning and check the inner status, it isn’t so bad but I can see many things to improve. I also need to know what’s that weird component that seem a “moisture resistor ” , anybody know what’s that thing ? I tried to put a drop of water on it but data seem doesn’t change ( humidity value stuck at 20%/22% ) , bit useless .
Im planning to put the temp sensor outside of the box making a little shield to prevent rain and moisture contact . Will post results soon .

Just tested and it’s a real “Moisture sensor” I just tried again with a drop of water on it and I reported after few minutes that the percentage of “ humidity “ changed from 22 to 80% , but only in the Auriol display, not in the ProCompact2 unit .