27-03-2020, 23:28
(27-03-2020, 04:14)Werk_AG Wrote: I designed a 3D printable basic enclosure for the WeatherDuino UPS board v1.3Werk,
Top cover can easily be removed by hand to inspect or change batteries. No screws.
Can be printed at 0.3 or 0.2 resolution.
Hope it be useful to someone.
Box includes some extra standoffs, because I use an extra step down converter (white type 1, magenta type 2).
Picture of the first version of this enclosure, without the WeatherDuino logo on the front panel.
File opens fine now,thanks
Could you post photos of the enclosure with the components installed
Regards
Jim

