22-02-2020, 22:50
Hi,
a few ideas where you could start looking:
Did you close the "run" switch?
If not the WeatherDuino will restart each time WeeWx is trying to connect.
Another possible thing: do you have the ch341 drivers intalled?
Last but not least, maybe you have selected the wrong device the WeatherDuino has a ch341 UART --> USB converter which emulates a virtual serial device.
At the moment you are "using" the USB device itself.
But here I'm at the moment very unsure because I can not check this on a linux machine at the moment.
a few ideas where you could start looking:
Did you close the "run" switch?
If not the WeatherDuino will restart each time WeeWx is trying to connect.
Another possible thing: do you have the ch341 drivers intalled?
Last but not least, maybe you have selected the wrong device the WeatherDuino has a ch341 UART --> USB converter which emulates a virtual serial device.
At the moment you are "using" the USB device itself.
But here I'm at the moment very unsure because I can not check this on a linux machine at the moment.