25-01-2020, 10:52
(23-01-2020, 23:50)Werk_AG Wrote: Haven't you saw your own graphs? So, why a new "factory reset" and a planned reset of the D1 for tomorrow?Hi, Caneira
Image bellow is from xxDvDxx, which is running since yesterday... untouched I think.
I also did the factory reset on the previous firmware release, but nothing had changed.
Now I did it again to see if anything had changed. The value of the Precipition Rate went to zero, but then I saw that it returned high after...
I wanted to redo the D1 reset because the problem of the Precipition Rate value that goes high, occurs every time for some reason the voltage drops and the module resets.
Then after this value drops, the Precipition Rate presents correct and real values like today.
thanks

