30-12-2019, 16:59
I would like to have support down to 5V because with phone chargers and USB-C chargers this is and will be very common. And you also will have some devices.
Since the actual solution does not satisfy myself fully I will look for some solutions allowing 5-15VDC at the input and 5-12VDC at the output... indipendent from the input.
I will also add some more diodes and maybe a resetable fuse to make it failsafe agaist wrong polarity of in- and output.
So stay tuned for the next version.
Nevertheless this one can be used for the Pro2. If someone likes a PCB you can buy some of the left prototypes for 3EUR + 3,70 EUR shipping.
Since the actual solution does not satisfy myself fully I will look for some solutions allowing 5-15VDC at the input and 5-12VDC at the output... indipendent from the input.
I will also add some more diodes and maybe a resetable fuse to make it failsafe agaist wrong polarity of in- and output.
So stay tuned for the next version.
Nevertheless this one can be used for the Pro2. If someone likes a PCB you can buy some of the left prototypes for 3EUR + 3,70 EUR shipping.