[hornychz]

Hi all,
i have question about IP...

I like use more WD wifi displays in my network, but... Each client use the NAT (different subnet)

Now the mainboard send broadcast packet and WD display catch this... Is any posibility write to WD sw exact IP adress of mainboard ?
Real example:

Client network 192.168.100.0 /NAT/ ----- main network 192.168.1.0 ------ (WD station is also clinet network) /NAT/ 192.168.1.0
I can connect WD station to main network 192.168.1.0 but in way to client is still one NAT...

When i know exact ip and port is easy make port maping, but when the WD dispaly just listen, is not possible map some port...

Any ideas ?
Tnx

Hello,

You can use "DHCP reservation" of permanent IP address for any equipment in you LANs. You have to put WD MAC Address
to your DHCP server and configure "permanent" (or "reservation") address od that MAC Address...

And after this step you can configure firewall (NAT, SNAT, DNAT) for sending any packet from any LAN to any LAN.

But, I think, I should be better to configure some VLANs on your WiFi (and router) and use more SSIDs then only one. After this you can
use the same IP subnet for all WeatherDuino equipments.