22-02-2015, 01:26
Hi All,
I've just completed the build of both the Tx and Rx boards. Both are now working well with all readings expected on the 20x4 LCD display.
However, I am unable to get Cumulus to connect to the Rx unit. I have set up the Cumulus software as described on this forum with the serial port number set to the number I see the Arduino nano on in Windows Device Manager. However when I press OK in the Cumulus station settings window, the Rx nano reboots and after 30 seconds I get the following message:
"Error -32701 while trying to initialise the station. Please check your connections and settings"
I've attached a screenshot of the message. I know the serial port works, as I have programmed the Arduino through it!
Any ideas would be much appreciated.
Zak
I've just completed the build of both the Tx and Rx boards. Both are now working well with all readings expected on the 20x4 LCD display.
However, I am unable to get Cumulus to connect to the Rx unit. I have set up the Cumulus software as described on this forum with the serial port number set to the number I see the Arduino nano on in Windows Device Manager. However when I press OK in the Cumulus station settings window, the Rx nano reboots and after 30 seconds I get the following message:
"Error -32701 while trying to initialise the station. Please check your connections and settings"
I've attached a screenshot of the message. I know the serial port works, as I have programmed the Arduino through it!
Any ideas would be much appreciated.
Zak