05-08-2014, 02:49
(05-08-2014, 00:10)Werk_AG Wrote: Try connecting them to the board. Or better, you could start with the DHT22 sensor...
Hi Werk_AG,
I'll try connecting Fine Offset stuff a little later, as I won't be allowed to drag it into the house

BTW, The DHT22 is connected and is reading but the decimal point seems to be in the wrong spot
Temp: 2.18 Hum: 3.26 = Temp: 21.8 Hum =32.6 (I was thinking that the RX board converted these values)
(05-08-2014, 00:10)Werk_AG Wrote: PS: Sometimes I reply to your posts as if I'm talking to everyone and not just with you. Sorry, I think you understand why.
hehe, no worries.

