09-05-2019, 04:13
(09-05-2019, 02:11)Werk_AG Wrote:(09-05-2019, 01:53)richaam Wrote: No worrys! I did check the voltage of each side against ground. The voltage was 0V for both R8 and R15 on the side feeding into the EPS12 module . I will try reheating the welds.
Thanks,
Adam
Considering the situation maybe this is a good sign. Perhaps those two resistors are broken. Can you measure them? They should be both 10K.
Rgs.
I went ahead and checked all the resistors on the board. I found 3 bad ones. R8 & R15 are measuring around 1K instead of 10K and R16 is measuring 5.5K instead of 10k.
I'm not sure what I did to cause this, but obviously the damage has been done. I will replace them and report back.
-Adam