[jarekh3]

Hi jarekh3,

after your design and comments about the ender 3, I dived deeply into 3d printing.
I ordered an Ender 3X and upgraded it with dampers, TL smoothers, belt tensioners, damping feet, BL Touch (auto bed levelling), two cable chains, a self designed bed handle with a nozzle cleaner + a self designed filament runout sensor, added a Rasp Pi with OctoPI, created a dry filament box and flashed Marlin Firmware.
I am very happy with the printer and now I feel comfortable enough to print your housing .

Could you please provide your settings to print? Am I right to assume, that you slice with cura?
Would it be possible, to provide a screenshot, or a summary of your slicer settings? Layer height, etc.

Thanks in advance!

Hi t3gathome

I prefer the program Slic3r PE (I do not like Cura).
The parameters I use are typical:
-layer heigh: 0,16 - 0,20mm
-vertical shells: 3
-horizontal shells: 3
-infill: 25%
-detect thin walls => off
-speed: about 45mm/s
nothing unusual...

TL smoothers

Hmmm....

dampers

such?

As you pull the belt more tightly, the motor axis tilts.