13-04-2019, 18:07
I am gradually getting my Weatherduino system up and running, it comprises a PRO2 TX PCB v 2.50, PRO2 RX+ v4.03 and a WD 4PRO v1.30Rev_A.
The indicated battery voltage is reading exactly ½ the actual voltage, e.g. my power supply is set to 10v, but the RX and WD both shown the battery voltage is 5v, I have used precision resistors so don’t believe this to be a hardware problem. Should I be adjusting something in the TX software or in the RX?
Thanks Andy
The indicated battery voltage is reading exactly ½ the actual voltage, e.g. my power supply is set to 10v, but the RX and WD both shown the battery voltage is 5v, I have used precision resistors so don’t believe this to be a hardware problem. Should I be adjusting something in the TX software or in the RX?
Thanks Andy