15-02-2015, 03:03
the SHT modules are all universally 0.1" headers, so are breadboard friendly. Anything not on this "standard" header size are noted in specs when you buy them - you can be very comfortable if it doesn't call it out specifically, you'll find 0.1" header.
Personally, I would NOT go with the SHT10 module you show that has both 0.1" header and the shielded connector (the blue board without the narrowed waist). The Sensiron data sheets all talk about managing heat transfer into the sensor by doing things like the others do, and the blue board does none of that so is likely more affected by the external conditions than they should be.
Personally, I would NOT go with the SHT10 module you show that has both 0.1" header and the shielded connector (the blue board without the narrowed waist). The Sensiron data sheets all talk about managing heat transfer into the sensor by doing things like the others do, and the blue board does none of that so is likely more affected by the external conditions than they should be.