12-03-2019, 01:24
I'm slowly getting the transmitter board (PRO TX V3.12) assembled and doing some checks as I go.
I found one strange result while checking the 5 volt pins. I don't seem to have any continuity between the 5v pin on the FAN SHT1X/DHT22 connector and the other 5V pins (for example on the I2C connector).
I do have continuity from the 5V FAN... pin to R11 and from 5V to pin 6 of the 'wind' RJ-11 jack.
All the other 5V pins seem to have continuity with each other.
I'm not sure if I've done something wrong or if there's a mistake in the schematic.
Can anyone help me?
I found one strange result while checking the 5 volt pins. I don't seem to have any continuity between the 5v pin on the FAN SHT1X/DHT22 connector and the other 5V pins (for example on the I2C connector).
I do have continuity from the 5V FAN... pin to R11 and from 5V to pin 6 of the 'wind' RJ-11 jack.
All the other 5V pins seem to have continuity with each other.
I'm not sure if I've done something wrong or if there's a mistake in the schematic.
Can anyone help me?