25-02-2019, 03:28
It was beautiful! 
Unfortunately no. I disassembled my Pro2 to install a AQM board inside the box and reuse the LCD.
I gave a look on the code and I haven't saw any reason for it don't work. Please check if the push button is an NO type.
The PB1 should work as always:
- One Click switches the LCD backlight
- Double Click shows System Info
- Long Press (5 seconds) resets the system with a factory reset.
Regards
Werk_AG

(24-02-2019, 04:07)uncle_bob Wrote: Do you still have one of these old RX boards around? If so, could you please check yours sometime to see if the extra info PB1 works on WeatherDuino_Pro2_v4.0_20180327 ? When I press it the unit resets.
Unfortunately no. I disassembled my Pro2 to install a AQM board inside the box and reuse the LCD.
I gave a look on the code and I haven't saw any reason for it don't work. Please check if the push button is an NO type.
The PB1 should work as always:
- One Click switches the LCD backlight
- Double Click shows System Info
- Long Press (5 seconds) resets the system with a factory reset.
Regards
Werk_AG

