[Barrow4491]

Hi Jim,

Thank you for your kind words about the WeatherDuino system.

I had suspected of that. I really recommend that you do a "factory reset" on the receiver. At 9AM it may reset the Today Rain to zero, but wrong values will continue stored on the eeprom, and on next boot up the problem will arrive again.

The option to use ”Atmega 328P (old bootloader)”, its available on the boards manager 1.6.21.
Once I know that boards manager v1.6.22 and v1.6.23 cause problems with the RX software, I never tested the TX software compiled with them, but there is a great change that it cause problems too.

AVR Boards 1.6.21 is safe for RX and TX software.

If you will chose to reprogram the TX using the avr boards 1.6.21, do the "factory reset" on the receiver after reprogramming the TX.

Regards

Werk,
Thanks will do