Looking at it more carefully, I don't thing either the SHT15 or the SHT21 (or the HTU21D, since both have the same chip and board form factors) will fit the plastic cover. Not without some tweaking/cutting.
You will notice the SHT10/1 board narrows a bit at some point and then widens to the part with the four pins. I think the idea is to leave the pins (and the plug they go into) outside of the cover. But the SHT15 (first pic bellow) narrow part is actually larger than the SHT10/1 one (second pic bellow) and will not fit.
![[Image: %24T2eC16JHJHkFFmGfp5KiBS!zK1qCYw~~60_57.JPG]](http://i.ebayimg.com/00/s/MTYwMFgxNjAw/z/ctgAAOxyDLZSAzK1/%24T2eC16JHJHkFFmGfp5KiBS!zK1qCYw~~60_57.JPG)
![[Image: sku_215503_1.jpg]](http://img.dxcdn.com/productimages/sku_215503_1.jpg)
Either way a board such as this one seems more handy:
![[Image: im130914001_5_1.jpg]](http://imall.iteadstudio.com/media/catalog/product/cache/1/image/9df78eab33525d08d6e5fb8d27136e95/i/m/im130914001_5_1.jpg)
I think I will use right angle pins with the SHT21.
![[Image: 6-pin-right-angle-male-header.jpg]](http://www.alpha-crucis.com/2981-4241-large/6-pin-right-angle-male-header.jpg)
Actually there is a world of right angle 4 pin connectors around ...
Does anyone know (or can better than me guess) the Pitch Spacing of pins in the SHT1x series boards? 1 mm? 2mm?
You will notice the SHT10/1 board narrows a bit at some point and then widens to the part with the four pins. I think the idea is to leave the pins (and the plug they go into) outside of the cover. But the SHT15 (first pic bellow) narrow part is actually larger than the SHT10/1 one (second pic bellow) and will not fit.
Either way a board such as this one seems more handy:
I think I will use right angle pins with the SHT21.
Actually there is a world of right angle 4 pin connectors around ...
Does anyone know (or can better than me guess) the Pitch Spacing of pins in the SHT1x series boards? 1 mm? 2mm?