Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

What I am planning & a few doubts
#5

List of parts I just ordered.

:: Generic for all units

[Image: s-l140.jpg]
3PCS Micro-controller Nano V3.0 ATmega328 5V/16M CH340G board For Arduino
(1 accounting for defect, mounting damage or in the best case scenario a possible additional TX unit)
http://www.ebay.com/itm/141287092498

:: Humidity & Temperature Sensors

[Image: s-l140.jpg]
Digital Temperature & Humidity sensor SHT15
(for outside TX unit, should work with long wires.
Costs twice an SHT11, likely not justified. But since I am at it and will invest the time, rather try to achieve the best possible quality)
http://www.ebay.com/itm/181192513879

[Image: s-l140.jpg]
SHT21 Digital Humidity And Temperature Sensor Module
(for outside TX unit, for use with a short wire or will need and I2C extender)
http://www.ebay.com/itm/221685877037

[Image: s-l140.jpg]
New HTU21D Temperature & Humidity Sensor Breakout Board Module
(limited by short wire or will need and I2C extender, can eventually replace the DHT22 inside)
http://www.ebay.com/itm/251643554884

[Image: s-l140.jpg]
DHT22/AM2302 Digital Temperature Humidity Sensor
(inside RX unit)
http://www.ebay.com/itm/221546295018

[Image: s-l140.jpg]
3x Plastic Cover for SHT10 SHT11 Temperature Humidity Sensor SCM
(should fit the SHT15 as well, not entirely sure about the SHT21, we will see...)
http://www.ebay.com/itm/381090103576

:: Pressure sensor

[Image: s-l140.jpg]
2 x 1PCS BMP180 Replace BMP085 Digital Barometric Pressure Sensor Module for Arduino
(1 as a spare)
http://www.ebay.com/itm/271453913203

:: Solar partion

[Image: s-l140.jpg]
http://www.ebay.com/itm/121222634881?_tr...EBIDX%3AIT
UVM-30A UV Detection Sensor Module Ultraviolet Ray Module for Arduino
http://www.ebay.com/itm/121222634881

[Image: s-l140.jpg]
2 PCS AD822ANZ DIP-8 AD822AN AD822 Rail-to-Rail Low Power FET-Input Op Amp
(1 as a spare)
http://www.ebay.com/itm/301222518099

:: RX Unit Specific Parts

[Image: s-l140.jpg]
2pcs DS3231 AT24C32 IIC Module Precision RTC Module Memory Module
(1 as a spare)
http://www.ebay.com/itm/371071190235

[Image: s-l140.jpg]
PC Board PCB Mount SMA Female Jack Nut Bulkhead Right Angle Connector new
(since I am a it, will fit the RX with re-transmitting capability for eventual future WD unit)
http://www.ebay.com/itm/261127442621

[Image: s-l140.jpg]
10PCS 2N7000 TO-92 MOSFET N-CHANNEL 60V 0.2A Transistor
http://www.ebay.com/itm/130963369289

[Image: s-l140.jpg]
Blue Display IIC/I2C/TWI/SP??I Serial Interface2004 20X4 Character LCD Module
http://www.ebay.com/itm/161095107719

[Image: s-l140.jpg]
Geeetech 433Mhz Superheterodyne 3400RF Transmitter and Receiver link kit,Arduino
http://www.ebay.com/itm/200974005470

:: TX Unit Specific Parts

[Image: s-l140.jpg]
3 x 1PC TMP36GT9 TMP36GZ 100%-Genuine New from ADI Low-Voltage Temperature Sensors
(1 for spares 1 for future additional TX unit)
http://www.ebay.com/itm/181092361353

[Image: s-l140.jpg]
2x 2PCS 433Mhz WL RF transmitter and receiver link kit for Arduino/ARM/MCU Good
(spares and space for a second TX unit)
http://www.ebay.com/itm/381090103576

Hope I got it all right.

Total spent, including shipping, the spares provisioned and the fact I purchased more sensors than actually required: 119,43 USD

Curiously enough, a number of dealers seem to be off on holidays. I guess because of Chinese New Year.

I am still missing a number of the small stuff, which I expect it would be easy to get either from local shops or from Farnell.
Reply


Messages In This Thread
What I am planning & a few doubts - by hvalentim - 31-01-2015, 13:59
RE: What I am planning & a few doubts - by werk_ag - 31-01-2015, 18:27
RE: What I am planning & a few doubts - by hvalentim - 31-01-2015, 18:54
RE: What I am planning & a few doubts - by AllanG - 01-02-2015, 09:38
List of parts I just ordered - by hvalentim - 11-02-2015, 16:09
RE: What I am planning & a few doubts - by werk_ag - 11-02-2015, 21:44
RE: What I am planning & a few doubts - by hvalentim - 12-02-2015, 00:06
RE: What I am planning & a few doubts - by werk_ag - 12-02-2015, 01:46
RE: What I am planning & a few doubts - by hvalentim - 12-03-2015, 20:01
RE: What I am planning & a few doubts - by Brett - 15-02-2015, 03:03
RE: What I am planning & a few doubts - by hvalentim - 18-02-2015, 21:02
RE: What I am planning & a few doubts - by meteoestarreja - 16-02-2015, 11:51
RE: What I am planning & a few doubts - by hvalentim - 05-03-2015, 21:28
RE: What I am planning & a few doubts - by meteoestarreja - 05-03-2015, 22:10
RE: What I am planning & a few doubts - by werk_ag - 06-03-2015, 01:58
RE: What I am planning & a few doubts - by hvalentim - 09-04-2015, 23:20
RE: What I am planning & a few doubts - by werk_ag - 10-04-2015, 00:15
RE: What I am planning & a few doubts - by uncle_bob - 10-04-2015, 10:30
RE: What I am planning & a few doubts - by hvalentim - 10-04-2015, 11:33
My RX Unit Case - by hvalentim - 13-04-2015, 02:14
RE: What I am planning & a few doubts - by jomimota - 24-05-2015, 19:16
RE: What I am planning & a few doubts - by hvalentim - 25-05-2015, 10:09
RE: What I am planning & a few doubts - by jomimota - 25-05-2015, 12:30
RE: What I am planning & a few doubts - by werk_ag - 13-04-2015, 02:45
RE: What I am planning & a few doubts - by hvalentim - 13-04-2015, 02:57
Stage one completed - by hvalentim - 24-04-2015, 19:10
RE: What I am planning & a few doubts - by hvalentim - 28-04-2015, 16:52
RE: What I am planning & a few doubts - by werk_ag - 24-04-2015, 23:10
RE: What I am planning & a few doubts - by hvalentim - 25-04-2015, 01:02
RE: What I am planning & a few doubts - by werk_ag - 29-04-2015, 01:19
RE: What I am planning & a few doubts - by hvalentim - 29-04-2015, 10:08
my external setup - by hvalentim - 28-05-2015, 12:36
RE: What I am planning & a few doubts - by werk_ag - 28-05-2015, 23:04
RE: What I am planning & a few doubts - by hvalentim - 29-05-2015, 12:05
RE: What I am planning & a few doubts - by Brett - 30-05-2015, 01:26
RE: What I am planning & a few doubts - by JT118 - 30-05-2015, 07:29
RE: What I am planning & a few doubts - by hvalentim - 19-10-2015, 10:30



Users browsing this thread: 1 Guest(s)