11-11-2018, 19:00
Thanks very much for the quick reply, I'm really getting excited about this project now! 
Just a few more questions:
1. Which receiver did you purchase? I believe there are 3 to choose from? Is there more than one transmitter?
2. What did you do for an enclosure? I guess the receiver, being inside, would not be too much of a problem but what about the transmitter? It would need a weatherproof box of some sort?
3. How about power for the transmitter, did you use a battery? I believe I saw a picture at some point and I seem to remember seeing an SLA (sealed lead acid) battery. Does the transmitter run on 12 volts? How much power does it use? It would be really great to have a small solar cell to charge the battery and could also be used as a sensor for solar radiation!? Maybe I'm getting ahead of myself now.
4. Did you have any problems connecting the sensors from the Fine Offset to the new transmitter? Are there input connections on the TX board, are they screw terminals or connectors? Did you use the temperature and humidity sensors from the Fine Offset or did you need to purchase something else?
5. Anything else I need to know?
Sorry for all the questions,
Gord
Just a few more questions:
1. Which receiver did you purchase? I believe there are 3 to choose from? Is there more than one transmitter?
2. What did you do for an enclosure? I guess the receiver, being inside, would not be too much of a problem but what about the transmitter? It would need a weatherproof box of some sort?
3. How about power for the transmitter, did you use a battery? I believe I saw a picture at some point and I seem to remember seeing an SLA (sealed lead acid) battery. Does the transmitter run on 12 volts? How much power does it use? It would be really great to have a small solar cell to charge the battery and could also be used as a sensor for solar radiation!? Maybe I'm getting ahead of myself now.
4. Did you have any problems connecting the sensors from the Fine Offset to the new transmitter? Are there input connections on the TX board, are they screw terminals or connectors? Did you use the temperature and humidity sensors from the Fine Offset or did you need to purchase something else?
5. Anything else I need to know?
Sorry for all the questions,
Gord