07-11-2018, 01:45
I don't know if with Weewx its possible to use multipliers (I think it is, but I'm not sure) as happens with Cumulus. In affirmative case you will benefit for using WeatherDuino extended wind resolution, and use a multiplier.
The multipliers to use are the same as with Cumulus.
It is OK use VP2_WIND_RESOLUTION set to 0 (no need for any multiplier). In this case, WeatherDuino follows the Davis standard, and wind gusts are presented in 1mph increments, instead of 0.72Km/h (0.447mph) when VP2_WIND_RESOLUTION is set to 2, and a multiplier of 0.448 is used on the software side.
The multipliers to use are the same as with Cumulus.
It is OK use VP2_WIND_RESOLUTION set to 0 (no need for any multiplier). In this case, WeatherDuino follows the Davis standard, and wind gusts are presented in 1mph increments, instead of 0.72Km/h (0.447mph) when VP2_WIND_RESOLUTION is set to 2, and a multiplier of 0.448 is used on the software side.