07-02-2015, 03:59
(07-02-2015, 02:32)tyntop Wrote: Hi,
I have another query with regards, to TX power supply, on the TX pcb the power supply connection has the following pins marked :
+Bat
12v
GND
As far as I am aware these connections also have something to do with showing the battery voltage in the software, So would I be correct when wiring this to the battery that you would have :
GND to negative/black terminal on battery
+Bat/12v to positive/red terminal on battery
I am hoping that I have understood this properly If not please let me know.
regards
tyntop
Here's a snippet from an upcoming magazine article on this matter

Quote:When powered by a solar system, the TX unit has the ability to allow remote monitoring of the battery voltage. Just connect the +Bat terminal to the +12v battery terminal, and the 12V terminal to the output of your solar charger controller. If the TX unit is powered by a power pack supply, just connect +Bat and 12V terminal together.

