26-10-2018, 05:35
(26-10-2018, 05:19)41south Wrote: I've also noticed that with the 'program' link open the board just runs normally, I thought I read somewhere that it should keep rebooting until the link is back in 'run' mode?
Hi,
With the Program / Run switch open it only reboots when a serial connection is started what happen per example, when we start Cumulus.
Regarding the Meduino board, is the serial port recognized when you connect the USB cable to computer? If not, maybe it was damaged.
The serial to usb chip on the Meduino board is very close to the diode that we should remove, be careful to not apply much heat when removing / replacing the diode.