26-10-2018, 02:53
Hi all
Have been beating my head against the wall trying to reprogram my RX Meduino board. In the past it seems reluctant to bring up the port in the Arduino IDE on my Macbook pro, but eventually works. I have no problem with any of the TX Nano boards, just the RX Meduino.
Today I have tried every combination of power on/off with the "switch" (I use a jumper) in program mode but to no avail.
Is there an alternative way to look at programming?
I even took it off the RX board and put the diode back in - still didn't work
Many thanks for any thoughts
Have been beating my head against the wall trying to reprogram my RX Meduino board. In the past it seems reluctant to bring up the port in the Arduino IDE on my Macbook pro, but eventually works. I have no problem with any of the TX Nano boards, just the RX Meduino.
Today I have tried every combination of power on/off with the "switch" (I use a jumper) in program mode but to no avail.
Is there an alternative way to look at programming?
I even took it off the RX board and put the diode back in - still didn't work
Many thanks for any thoughts
41south.net.nz powered by WeatherDuino and Weewx