19-10-2018, 07:09
(19-10-2018, 04:59)Werk_AG Wrote: If your though are about using the AQM T/H sensor as your main outdoor T/H sensor, it can't and shouldn't be done, and there are many reasons for this: one of them could be that the AQM T/H sensor, most of the times is installed inside the AQM box (and it should be) near the Dust Sensor, because their main purpose is provide Air Moisture data, to allow compensation of the readings given by the Dust sensor, which should be compensated depending on the RH%My setup is a bit different from the usual. All my electronics is in the one box with air forced over all the sensors, PCB's and heat sinks. I think it works well.
So I think using the AQM temps data as the main Outdoor temp sensor would work OK, at least while replacements arrived. I'm off to order some SHT31's for stock now but I thought my idea may have had merit.
Thanks for the feedback though
Cheers UB