Hi all
I'm slowly progressing with building and testing. Today I hooked up my Davis anemometer (7911) which is from a Wizard III station. The wiring all checks out as per the usual diagrams, the direction pot is 20k and the reed switch is 1 pulse per rev.
But .....
On the internal web server of the station I see direction changes, but no wind recorded at all.
On the TFT of the Rx unit there is nothing, no direction and no wind speed.
It's been running for a couple of hours with a slight breeze. I can see pulses on the black wire so wind should be recorded.
Am I right that JP2 and R6 are not required for my hardware?
I have windspeed_sensor set at type 30
What is the best way to debug this please?
I'm slowly progressing with building and testing. Today I hooked up my Davis anemometer (7911) which is from a Wizard III station. The wiring all checks out as per the usual diagrams, the direction pot is 20k and the reed switch is 1 pulse per rev.
But .....
On the internal web server of the station I see direction changes, but no wind recorded at all.
On the TFT of the Rx unit there is nothing, no direction and no wind speed.
It's been running for a couple of hours with a slight breeze. I can see pulses on the black wire so wind should be recorded.
Am I right that JP2 and R6 are not required for my hardware?
I have windspeed_sensor set at type 30
What is the best way to debug this please?
41south.net.nz powered by WeatherDuino and Weewx