[41south]

Hi all

I was initially using the BME280 for temp/hum/baro on my RX board. I was unsure of the temp/hum readings of this sensor, they seemed a little high, so I've added a SHT31 sensor to take temp/hum readings from - leaving the BME280 just for baro.

My config is as below, but I no longer have baro/ATM readings on the display. Temp and hum are reading fine.

Code:

// --------------------------------------------------------------------------------------
//   Define the type of your Barometric Pressure Sensor
// --------------------------------------------------------------------------------------
#define BAROMETRIC_SENSOR  0   // 0= BME280, 1= BMP280 2= BMP085 / BMP180


// --------------------------------------------------------------------------------------
//   Define the type of your inside Temperature / Humidity Sensor
// --------------------------------------------------------------------------------------
#define INSIDE_TH_SENSOR   3   // 0= BME280, 1= HTU21D, 2= SHT21, 3= SHT31

WeatherDuino Pro2 PLUS Receiver - Version: P2AT2560_RX_v7.0_b003


Any help would be appreciated to troubleshoot this one, baro was fine until I changed. Is this not a compatible configuration?

Thanks
Colin