[engolling]

Hello engolling,

Indeed Jarekh3 did a great job with the design of the enclosure for the WeatherDuino Pro2 PLUS receiver. I ever wished to see something like that.
I believe the Jarekh3 case, with minimal modification, can also be used for the WeatherDuino Pro2 Compact as also for the Wifi Wireless Display units (both are of the same size).

Regarding your case, don't you think that the front face is quite big for a so small device? Perhaps a rectangular shape will give a better aspect ratio in relation to screen size. This is just an opinion, please don't see it as a criticism.

Regards

Hello Werk,
thank you for your feedback.

Even criticism is not a bad thing when it is factual and you only get better if there is someone who encourages you to think again over your ideas. But I think this mindset got a bit lost when communicating via internet nowadays because a lot of people take the feedback personally or even the feedback is nor written objective.

But BTT:
The reason why the housing is so big, was that I wanted it symmetrically (thought this is a good idea without any further knowledge) and I wanted it to contain a small 433MHz antenna. The first idea was born, when WiFi transmission was not possible.
So it may get smaller again with the next prototype version.

With the actual version I wanted a proof on concept of the display mounting and how to plug the micro usb.

Best Regards,
engolling