01-09-2018, 15:13
Hello Werk,
here some new feedback - my last post has been swallowed by the hoster changing of the forum, so here my feedback again:
I did further investigation of this issue.
The SHT31 library only blocks if the sensor is really defective - I think this is because the internal i2c routines of Arduino get stuck.
So the library is fine, and it continues on if the sensor is disconnected.
Maybe I can do some further research on this topic if I have time, but otherwise I think it is OK to leave it like it is at the moment because this was some false alert of me.
regards,
engolling
here some new feedback - my last post has been swallowed by the hoster changing of the forum, so here my feedback again:
I did further investigation of this issue.
The SHT31 library only blocks if the sensor is really defective - I think this is because the internal i2c routines of Arduino get stuck.
So the library is fine, and it continues on if the sensor is disconnected.
Maybe I can do some further research on this topic if I have time, but otherwise I think it is OK to leave it like it is at the moment because this was some false alert of me.
regards,
engolling