24-08-2018, 21:01
(24-08-2018, 20:34)ok2arm Wrote: ... problem was be on the output from CO2sensor, I found crack way on pcb, near output pin... Because was be read ok and sometimes not...
It should not happen but is impossible to say that it will not happen even with good quality PCB's
If possible send me by PM a closeup picture of the damaged via.
(24-08-2018, 20:34)ok2arm Wrote: And last problem is in RX unit, RX dont roll bettwen PM2,5 and PM10 as WD... Can you ask me, whitch part SW is for changing 2,5/10 ? On the LCD is just 2,5
Tnx
Well, this one is easy for me to answer
That feature wasn't implemented in the Pro2 PLUS RX software yet. It shows only the PM2.5 values, which are the ones used to compute AQI
Maybe it will be implemented on next release...
Regards