[werk_ag]

Just got around to soldering in the new RX module and ...it all works! I have simply soldered some wire to the ANT pin for an antenna.

Actually, the range is even better than before - signal is going through 3 stone walls of about 50 cm thickness, and about 80 metres to get to my shed. Efficiency is only about 50%, but couldn't get a signal at all in my shed before  - the RX had to be in my kitchen, about 50M and one wall from TX. I will play around with the system tomorrow to get efficiency a bit better.

Pleased to have weatherduino working again.

Heeby

You should thank to your "over excited puppy".
I'm glad to know that your system is working again even better than before. Some times a single wire works better than some types of antennas.
Thanks for the update.