13-07-2018, 16:49
Hi,
The debug output of serial monitor is human readable, try open it at 19200 baud.
Do you have any Transmitter unit already sending data?
If you have a multimeter, try measure the output voltage of the 3.3V regulator.
The debug output of serial monitor is human readable, try open it at 19200 baud.
Quote:The wi-fi is not showing up on scanning my network.That is the normal behaviour, the device runs in ST (station) mode not in AP mode.
Do you have any Transmitter unit already sending data?
If you have a multimeter, try measure the output voltage of the 3.3V regulator.