15-03-2025, 04:00
I think I have posted the Config options file (I changed the .h to txt as the system has not accepted the .h) and also another file of the uploads to the ESP32.
I have delayed replying since I have updated my computer and using a more current Mac with up to date MacOS 15.3.1 and used this setup to program the receiver. The settings for the board are as you listed and the Arduino is 1.8.19 , ESP32 library is 2.0.14. There are no extra libraries or files from other arduino programs other than those in the original Arduino download, ESP32 library update to 2.0.14 and those included in the weatherduino download. The libraries and tools for the weatherduino were transferred into the Arduino folder (in Documents in the Mac system).
I have used Terminal program to erase the ESP32. and then loaded the "SPIFF". and then the weatherduino program .
The upload report files are attached. There are some "errors" which I don't understand during the compiling but the program uploads Ok then. if I redo the upload again in the same session the file is uploaded and these compiling issues are not seen.
I think the programming seems to have gone well and the receiver boots up , recognizes the WIFI , recognizes the transmitter with all readouts of wind, rain , temperature , UV and solar . The air quality sensor is also seen.
However the same bombing /freezing issues seem to be persisting despite changing my computer, MacOS etc .
It bombs with either the screen freezing or it goes into a blank white screen : I was getting again up to half a day of readings rarely but mostly it last 10 seconds or less or maybe a minute or two.
In addition the receiver will usually not boot again if I have left it on for a longer period unless I leave it powered off for an extended period (maybe an hour or more). After this it will then usually start again when power is applied.
Paul
I have delayed replying since I have updated my computer and using a more current Mac with up to date MacOS 15.3.1 and used this setup to program the receiver. The settings for the board are as you listed and the Arduino is 1.8.19 , ESP32 library is 2.0.14. There are no extra libraries or files from other arduino programs other than those in the original Arduino download, ESP32 library update to 2.0.14 and those included in the weatherduino download. The libraries and tools for the weatherduino were transferred into the Arduino folder (in Documents in the Mac system).
I have used Terminal program to erase the ESP32. and then loaded the "SPIFF". and then the weatherduino program .
The upload report files are attached. There are some "errors" which I don't understand during the compiling but the program uploads Ok then. if I redo the upload again in the same session the file is uploaded and these compiling issues are not seen.
I think the programming seems to have gone well and the receiver boots up , recognizes the WIFI , recognizes the transmitter with all readouts of wind, rain , temperature , UV and solar . The air quality sensor is also seen.
However the same bombing /freezing issues seem to be persisting despite changing my computer, MacOS etc .
It bombs with either the screen freezing or it goes into a blank white screen : I was getting again up to half a day of readings rarely but mostly it last 10 seconds or less or maybe a minute or two.
In addition the receiver will usually not boot again if I have left it on for a longer period unless I leave it powered off for an extended period (maybe an hour or more). After this it will then usually start again when power is applied.
Paul