22-02-2019, 02:10
Hi Zak,
The Config_Options seems good (supposing the CO2 sensor is a model B) as also the output of DEBUG_CO2. You may also enable the DEBUG_PM to check if the Dust sensor is being read. The Dust sensor should be read 40s after the end of the CO2 init sequence.
After checking that both sensors are being read, disable both Debug options and upload the code again.
When both sensors are in use, data may take a little more time to be updated on the receiver (1 to 3 minutes).
Please report back.
Regards
The Config_Options seems good (supposing the CO2 sensor is a model B) as also the output of DEBUG_CO2. You may also enable the DEBUG_PM to check if the Dust sensor is being read. The Dust sensor should be read 40s after the end of the CO2 init sequence.
After checking that both sensors are being read, disable both Debug options and upload the code again.
When both sensors are in use, data may take a little more time to be updated on the receiver (1 to 3 minutes).
Please report back.
Regards