[tyntop]

Hi.

I have built a  new TXv3.12 board, and I am hoping to use inspeed components for the wind speed/ wind direction.

I have the sensor boards which I am hoping are the ones used in the 8 pulse version of inspeed anemometer and the inspeed E vane 2.

I am Aware that these 2 sensors have a 5v supply.

I am looking to use vero-board

I think that I have worked out the pins for the wind connection terminal on the TX board :

1 = 12v
2 = gnd
3 = gnd
4 = D3
5 = A3
6 = 5v

I am looking for a diagram/circuit of a inter-connection board that would be suitable to connect these 2 sensors , showing the wiring and any resistors/ capcitors reccomended.

Any advice and help will be most appreciated.

thanks in advance

tyntop