06-06-2016, 04:32
(06-06-2016, 03:59)spudstrawb Wrote: The rain sensor is now working. I tested the reed switch and it seemed okay. Further investigation showed that I needed to change the pins that the relevant wires were attached to in the RJ11 plug for it to work with WeatherDuino. A new plug was fitted with the relevant wires connected to the appropriate pins and it is now working. I did a quick and dirty calibration and it suggests that the sensor is not consistent with either Davis or FO standards. I will have to do a proper calibration. Making progress though.
Do you know the value corresponding to each tip?
You may have to set it on the weatherduino software, and very important, don't forget to adjust the Cumulus multiplier accordingly.
Check this topic: http://www.meteocercal.info/forum/Thread...figuration