[werk_ag]

3D Printed Radiation Shield for Meteo Stations - Part 2

The Parts

After the overall view, we are now going to focus on the elements needed for building our Radiation Shield.

List of the 3D printed parts:

• The top plate: 1 unit
  
• The middle plates: 5 units (if needed can be more)
  
• The base to fix the sensor mounting piece: 1 unit
  
• The wall (or pipe) mounting piece: 1 unit
  
• The sensor mounting piece: 1 unit
  
• The sensor protection chamber: 1 unit
  
• The box for additional electronics (optional): 1 unit
  
• The bottom cover for the optional box: 1 unit
  

The pictures below show each part by the order they are listed.

.........

.........

List of other hardware parts:

• Three M4 rods with 12cm (size is for an assembling with 5 middle plates. Increase 2cm by each additional middle plate)
  
• Three M4 nuts
  
• Three washers suitable for M4 size
  

These are all the parts we need to build the Radiation Shield. On next topic we will focus on assembling.

Continue on next topic...