Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

soldering station
#1

Hi all

my soldering station is  a Yihua 8786D - i believe it is rated at 50w

will that be suitable to use for my project ?

thanks
geoff
Reply
#2

(11-10-2022, 12:49)gtbwise Wrote:  Hi all

my soldering station is  a Yihua 8786D - i believe it is rated at 50w

will that be suitable to use for my project ?

thanks
geoff

 Hi Geoff,

This power should be enough to easily heat small surfaces.
Soldering the SMA antenna-entree should still be possible using flux.

There are not really large surfaces to solder on the print.

Kind regards,
Wim
Reply
#3

thanks Wim

geoff
Reply
#4

reading manual it seems i can get the following from the iron
Work voltage 26V±10% 50Hz/60Hz
Temperature range 200 °C ~480 °C
Temperature stability ±2 °C (Static state)
Tip-to-ground impedance <2Ω
Tip-to-ground voltage <2mV

geoff
Reply
#5

on inspection i found the ceramic heating core was broken on the iron, so i have ordered 2 new ones and a range of tips (10)

the unit also has the air gun which might come in handy

geoff
Reply
#6

The power of your soldering iron is good for the job, the most important is using a thin tip.
Reply
#7

(13-10-2022, 18:12)Werk_AG Wrote:  The power of your soldering iron is good for the job, the most important is using a thin tip.

thanks Werk

geoff
Reply




Users browsing this thread: 1 Guest(s)