https://www.meteocercal.info/forum/ Mon, 25 May 2026 08:17:38 +0000 MyBB https://www.meteocercal.info/forum/Thread-System-not-start-up Fri, 16 Jul 2021 22:55:19 +0100 catliNZ]]> https://www.meteocercal.info/forum/Thread-System-not-start-up Re setting up the solar radiation board with tx software v7.0_b003.
I changed the tx config setting #define ID4 from 0 to 1  and uploaded the sketch to the tx unit.
On it restarting and then turning on the rx, the rx only highlights the W symbol (R and T stay red) even after 3 minutes.
I can then change the ID4 setting back to 0, reload the software and rx starts correctly.
This was done both on the bench with no sensors attached and with the tx in its usual setup.

Are there other changes I should be making when adding the solar board?

thanks, Ian]]> Re setting up the solar radiation board with tx software v7.0_b003.
I changed the tx config setting #define ID4 from 0 to 1  and uploaded the sketch to the tx unit.
On it restarting and then turning on the rx, the rx only highlights the W symbol (R and T stay red) even after 3 minutes.
I can then change the ID4 setting back to 0, reload the software and rx starts correctly.
This was done both on the bench with no sensors attached and with the tx in its usual setup.

Are there other changes I should be making when adding the solar board?

thanks, Ian]]>