Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5

The Weatherduino Pro2 Plus software no longer starts
#5

(09-03-2021, 15:34)hornychz Wrote:  Hello, bombenm,

When starting the RX unit, you should wait until all three TWR letters go from red to green. During this time, the "diagnostic" LED
will also light up, indicating that the connection to the transmitters has not yet been properly established. At this time, you should
neither touch the screen nor start the weather software.

Normally, this time lasts about 5 minutes, but in the case of poor signal reception of the transmitters, it can be stretched several times.
So try to persevere for at least 15 to 20 minutes and if the RX unit does not "jump", please respond again.

Good luck!

Hello hornychz,

I left the inisalization process for hours. The result was that,  after several minutes, the receiver shows the big clock without wifi or internet connection.
Before,  I try to upload the software in Test mode. comm led went off. Wi-Fi is working. I would like to do others tests in order to found where is the Issue. Thank you.
Reply


Messages In This Thread



Users browsing this thread: 1 Guest(s)