If it doesn't show even the welcome screen, recheck all the solder points.
If it shows the welcome screen and then goes blank, please tell me what software version are you using.
(30-06-2015, 17:58)Werk_AG Wrote: [ -> ]If it doesn't show even the welcome screen, recheck all the solder points.
If it shows the welcome screen and then goes blank, please tell me what software version are you using.
Ok I have carefully checked the cables I made and a wire was not properly crimped into the contact.. now it's fixed and the RX works fine!
Hi, zitoune
Glad to know that the LCD is now work as it should.
Thanks for the feedback.