Hi all
my soldering station is a Yihua 8786D - i believe it is rated at 50w
will that be suitable to use for my project ?
thanks
geoff
(11-10-2022, 12:49)gtbwise Wrote: [ -> ]Hi all
my soldering station is a Yihua 8786D - i believe it is rated at 50w
will that be suitable to use for my project ?
thanks
geoff
Hi Geoff,
This power should be enough to easily heat small surfaces.
Soldering the SMA antenna-entree should still be possible using flux.
There are not really large surfaces to solder on the print.
Kind regards,
Wim
reading manual it seems i can get the following from the iron
Work voltage 26V±10% 50Hz/60Hz
Temperature range 200 °C ~480 °C
Temperature stability ±2 °C (Static state)
Tip-to-ground impedance <2Ω
Tip-to-ground voltage <2mV
geoff
on inspection i found the ceramic heating core was broken on the iron, so i have ordered 2 new ones and a range of tips (10)
the unit also has the air gun which might come in handy
geoff
The power of your soldering iron is good for the job, the most important is using a thin tip.
(13-10-2022, 18:12)Werk_AG Wrote: [ -> ]The power of your soldering iron is good for the job, the most important is using a thin tip.
thanks Werk
geoff