WeatherDuino Forum

Hi

I have a 3d printed enclosure to your design, for my new AQMlll .     

I have to purchase some  self tapping screws to:-

1. Secure the Oled display to the lid and

2. Secure the lid to the box.

I am a bit worried about getting the correct diameter and length screws, as I do not wish to break the printed bosses on the lid and in the box.

Please can you advise me of the correct diameter and length screws for the job?

many thanks

Patrick

Hi Patrick,

Secure the lid to the box - M3 8mm to 9mm length
Secure the Oled display to the lid and - I'm not sure, but I think I used M1.7 5mm

Rgs.
Werk_AG