WeatherDuino Forum

When set to use inHg the 2.8" TFT display correctly shows the pressure, for example, as 29.97 inHg, but the internal webpage of the Pro2+ rounds the pressure to 30.0 inHg. Is there any way to get it to read 2 decimal places when using inHg?


TIA

Hi,

From your post here, I took note of this issue.
It will be done on next software release.

I wasn't sure if you saw that post or not.

Thank you.

It works, thanks!

[Image: l1EBgrA.jpg]